Fencing Installation- Info

Before you start building your new fence, you may want to know the process of installing it. This article will walk you through the process step-by-step. Before you start the project, it is important to contact your local utility marking service to mark the area where you will be digging the posts. This way, your fence company can accurately determine the best location for your posts. Ensure that you mark all utilities on your property so that you are not surprised by a bill at the end. Fencing services at True Built Fencing in Austin, Texas

If you’re using wire, you should be aware of the fact that the material shrinks after a prolonged period of exposure to cold weather. Therefore, you’ll have to be careful while choosing the wire to prevent it from contracting. Also, when using concrete, you’ll need to set concrete anchors that are 20 square inches and 3.5 feet deep. When setting the posts, be sure to place the braces into these concrete anchors to prevent the wire from sagging.
Next, you’ll need to apply stain. If your fence is made from rough-sawn cedar, you’ll need to apply a coat of latex stain before applying the stain. This stain will help prevent the wood from rotting and will also keep water out of the end grain, which is where most rot develops. Finally, make sure you use a quality fence stain before you start the process.
After you’ve selected the fence style, the next step is to prepare the site. You should have the post brackets inserted into the hole before you start the actual fence building. Make sure you’ve checked the location of underground power lines before digging. If you have any doubts, call your local power company to conduct a free inspection. Otherwise, you’ll end up with a fence that’s ugly and won’t last.
Next, you need to prepare the fencing material. Depending on the type of fence you’re building, you can either buy panels or make your own. Choose a style and type that will best suit your fencing needs. Typically, you should choose fence panels that have a rough and smooth side and are spaced evenly between them. You may also need to rip end boards of a panel to make them a specific width.
Once you’ve marked the fence posts and prepared the fence site, the next step is to install the rest of the fence. If your fence is six feet or less tall, place posts every six to eight feet along the fence line. They should be spaced evenly and be the same distance apart. To install the posts, use a post hole digger or a two-person auger. If you’re using wooden fence, you will need to treat the posts with wood preservative to prevent rotting.
Once you’ve measured the length of your fence and the width of each individual picket, you can now proceed to install the gate. You can either make the gate from partial panels or rails and pickets, as long as it fits the rest of the fence. You should then divide your linear footage by the width and spacing of your pickets. Then, divide that number by eight to calculate the length of your fence posts.

This entry was posted in Business. Bookmark the permalink.